Mazda 626

1991-1998 of release

Repair and car operation

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine of 2,0 liters
   - 3.7. Systems of electric equipment of the engine
      3.7.1. Introduction
      3.7.2. Technical characteristics
      3.7.3. Accumulator
      - 3.7.4. Ignition system
         3.7.4.1. Ignition coil
         3.7.4.2. Electronic control unit of system of ignition
         3.7.4.3. Ignition distributor
      3.7.5. System of additional charge of the accumulator
      3.7.6. Generator
      + 3.7.7. Starter and system of start of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice

3.7.4.3. Ignition distributor

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.

2. Disconnect wires from the ignition distributor.

3. Uncover the distributor and turn a cranked shaft of the engine so that the tip a begunka was turned to the N1 cylinder plug.

4. Make a mark in the distributor case directly under a tip a begunka.

5. Also mark the provision of installation of the distributor on a head of the block of cylinders.

6. Turn off fixing bolts and remove the distributor.

Installation

PERFORMANCE ORDER

1. Establish a new sealing ring on the distributor case.
2. Establish the distributor on a head of the block of cylinders in the same situation, as well as before removal. Check, that coincided made before a mark.
3. Acquire fixing bolts.
4. Further installation is carried out upside-down removals. Check a corner of an advancing of ignition and reliably tighten fixing bolts.