Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   - 3.3. Petrol V6 engine (2,5 liters)
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Recommendations about repair
      3.3.4. Top dead point of the first piston
      3.3.5. Covers of heads of cylinders
      3.3.6. Springs, clamps and epiploons of valves
      3.3.7. Gas-distributing belt and asterisks
      3.3.8. Camshafts and pushers
      3.3.9. Inlet collector
      3.3.10. Final collectors
      3.3.11. Heads of cylinders
      3.3.12. Forward epiploon of a cranked shaft
      3.3.13. Oil pallet
      3.3.14. Oil pump
      3.3.15. Flywheel or leading disk
      3.3.16. Back epiploon of a cranked shaft
      3.3.17. Engine fastenings
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine of 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


Samsung LE32B450C7WXRU прошивка

3.3.13. Oil pallet

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Lift and fix a forward part of the car.
3. Remove the bottom guard of the engine.
4. Merge engine oil and remove the oil filter.
5. Get щуп for measurement of level of oil.
6. Disconnect a wire from the oxygen sensor. Disconnect an exhaust pipe from a final collector and lower a pipe together with the catalytic converter.

7. Unscrew bolts and remove the oil pallet.

Installation

PERFORMANCE ORDER
1. Carefully clean and wipe solvent or acetone being joined surfaces of the pallet and the block of cylinders.
2. Clean openings of bolts in the block of cylinders.
3. Examine the oil pallet on existence of cracks and other damages.
4. Put hermetic on a flange of the oil pallet.
5. Establish the pallet and tighten bolts.
6. Establish the remained details, get the engine and check the oil pallet on existence of leaks.