Mazda 626

1991-1998 of release

Repair and car operation



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   - 3.5. Partition of engines (2,0 and 2,5 liters of V6)
      3.5.1. Introduction
      + 3.5.2. Technical characteristics
      3.5.3. Repair work without engine dismantle from the car
      + 3.5.4. Major maintenance of the engine
      3.5.5. Check by means of a vacuum measuring instrument
      3.5.6. Compression check
      3.5.7. Methods of dismantle of the engine
      3.5.8. Removal and engine installation
      3.5.9. Engine partition
      3.5.10. Partition and check of a head of cylinders
      3.5.11. Valves
      3.5.12. Assembly of a head of cylinders
      3.5.13. Removal of pistons and rods
      3.5.14. Removal of a cranked shaft
      3.5.15. Check of the block of cylinders
      3.5.16. Honingovaniye of cylinders
      3.5.17. Check of pistons and rods
      3.5.18. Check of a cranked shaft
      3.5.19. Check and selection of radical bearings and bearings of rods
      3.5.20. Check of camshafts and pushers
      3.5.21. Engine assembly order
      3.5.22. Installation of piston rings
      3.5.23. Installation of a cranked shaft
      3.5.24. Installation of a back epiploon of a cranked shaft
      3.5.25. Installation of pistons and rods
   + 3.6. Diesel engine of 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electroschemes
+ 14. Good advice


course c++

3.5.18. Check of a cranked shaft

PERFORMANCE ORDER
1. Clear a cranked shaft solvent and dry up it the compressed air.
2. Examine bearings of a cranked shaft on existence of wear tracks, scratches, corrosion or cracks.
3. Remove jags round lubricant openings and clean openings solvent.
4. Examine a cranked shaft on existence of cracks or other damages.
5. Measure diameters of radical and shatunny bearings. To reveal a konusnost and ovality, measure diameter of each of bearings in several points. If necessary the cranked shaft needs to be processed in a specialized workshop.
6. Check necks of epiploons of a cranked shaft on existence of wear tracks or damages. If epiploons wiped flutes on necks, new epiploons will pass oil.
7. Measure length of a carving of each of bolts of covers of radical bearings. In four-cylinder engines of a carving of bolts 67,5 mm should be not longer, and in six-cylinder engines 136 mm (for long bolts) are not longer and (for short bolts), otherwise bolts it is necessary to replace 119 mm.