|
|
Mazda 6261991-1998 of releaseRepair and car operation |
|
|
Mazda 626 + 1. Maintenance instruction + 2. Maintenance + 3. Engines + 4. Heating and ventilation + 5. Fuel system + 6. Exhaust system + 7. Transmissions + 8. Coupling and semi-axes + 9. Brake system + 10. Running gear + 11. Body - 12. Electric equipment 12.1. Introduction 12.2. Search of a source of malfunction in electric equipment system 12.3. Safety locks 12.4. Automatic switches 12.5. Relay 12.6. Breaker of indexes of turns / alarm system 12.7. Switches on a steering column 12.8. Switch of ignition and lock drum 12.9. Switches on the dashboard 12.10. Tools of an instrument guard 12.11. Instrument guard 12.12. Radio receiver and loudspeakers 12.13. Aerial 12.14. Bulbs of headlights of head light 12.15. Headlights of head light 12.16. Drive of headlights of head light 12.17. Replacement of bulbs 12.18. Engine of screen wipers 12.19. Horn of a sound signal 12.20. System of day inclusion of headlights 12.21. Heater of back glass 12.22. System cruise control 12.23. Electric window regulators 12.24. Central lock and remote control by the central lock 12.25. A rear-view mirror with the electric drive 12.26. Top hatch 12.27. Safety airbag + 13. Electroschemes + 14. Good advice Правильное расположение деревьев снижает расходы на отопление на 30% |
12.3. Safety locks
Removal of a cover of the block of safety locks The block of safety locks in an impellent compartment Check of a condition of the block of safety locks
Electric chains of the car are protected by a set of safety locks, switches and burned-through crossing points. The block of a box of safety locks includes a box of safety locks, wires and their sockets of connection and is located behind the dashboard on the party of the driver.
Each of safety locks protects the chain and its belonging to this or that chain is designated on a cover of a box of safety locks. Tiny safety locks with flat plugs are established in the block of safety locks.
In case of an exit of any element of electric equipment out of operation, first of all it is necessary to check safety locks. It is easy to define fused safety lock visually via the transparent plastic case. Also, flat plugs of connection of safety locks are visible in the block of safety locks and it is possible to check a chain continuity.
It is very important to use safety locks of the demanded capacity. Various electric chains demand protection against currents of various capacity. The most admissible size of a current for a chain is designated in amperes on the safety lock case by color code designations and on a cover of a box of safety locks. Prevention If the safety lock fuses right after replacement, do not replace it again, yet do not establish and do not eliminate a cause of defect. In most cases, the cause of defect is the short circuit caused by the come-off or old wire.
The oven and the conditioner consume a large number of the electric power therefore the box of safety locks has the switch for protection of their chains. If the chain is disconnected by the switch, switch off an oven and the conditioner before that, to press the button of reinstallation of the switch. The block of safety locks is located on the left side of the dashboard. The second block of safety locks is located under the dashboard on the party of the driver. It is possible to define fused safety lock visually. |
|